Recording (Aj-D450 Only) - Panasonic AJ-D440 Operating Instructions Manual

Recording
(AJ-D450 only)
1
2
3
4
5
6
<Notes>
•
Check that the SERVO lamp is lighted during recording. If it flashes or if it is off, the
images played back will be disturbed.
•
The sound and pictures to be recorded are offset from the playback pictures by 5 frames
and recorded. When, for instance, recording sound at a particular timing while the
playback pictures are monitored, the sound to be edited will be recorded at a position
which is offset from the playback pictures by 5 frames.
Set the accidental erasure prevention tab on the cassette tape to the "recording"
position and insert the tape.
Press the STOP button to place the unit in the stop mode.
Check that the REC INHIBIT lamp is off.
Select the video and audio input signals and adjust their levels.
4-1
Selecting video/audio input signals
1
Connect the signals to be recorded.
2
Select the input signals using the INPUT SELECT switches on the front
panel.
4-2
Adjusting the audio level
Adjust the audio input signal levels of the analog audio CH1/CH2 signals. When
set at the center position, audio signals will be recorded at the proper level.
Press the PLAY button while holding down the REC button. The REC and PLAY lamps
light, and recording commences.
To end the recording, press the STOP button.
Recording is ended, and the unit goes into the stop mode.
– 23 –