Panasonic AJ-D440 Operating Instructions Manual page 33

USER menu
<OPERATION>
No.
109* EJECT EE
110* F/R EE SEL
111* STOP EE
112
113
114* REC
115
The underline on the setting item denotes the initial setting.
* The Setup menu can only be displayed for the model AJ-D450.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
0000
SEL 0001 BLACK
0000
0001
0000
SEL 0001
AUTO REW 0000
0001
MEMORY 0000
STOP 0001
0000
INHIBIT 0001
STOP 0000 NORMAL
RESPNS 0001
– 33 –
EE This selects whether EE mode or BLACK is to be used during
EJECT status.
0:
EE mode
1:
Video blackens, audio mutes.
EE This selects whether EE mode or playback mode is to be
used during FF/REW operations.
TAPE
0:
EE mode
1:
Playback mode
EE This selects whether EE mode or playback mode is to be
used during stop mode.
TAPE
0:
EE mode
1:
Playback mode
<Note>
The STAND-BY OFF mode complies with the above selection.
When TAPE is selected, however, the video becomes grey.
This selects whether to rewind the tape automatically to the
OFF
tape start when the tape end is detected.
ON
0: The tape stops at the tape end.
1:
The tape is rewound to the tape start.
This selects whether the VTR is to stop automatically when
OFF
the counter value reaches "0" during a fast forwarding or
ON
rewinding operation in the CTL mode.
0:
The VTR does not stop.
1:
The VTR stops automatically.
<Notes>
1.
The stop mode concerned is either the stop or the still-
picture (SHTL STILL) mode depending on the setup menu
No. 313 (AFTER CUE-UP) setting.
2.
When both the AUTO REW function and MEMORY
function have been selected at the same time, the AUTO
REW function takes precedence.
This selects whether to allow (enable) or prohibit (disable) the
OFF
recording of signals on the cassette tape.
ON
0:
Signals can be recorded on the cassette tape when the
cassette's accidental erasure prevention mechanism is
set to the recording enable position.
1:
Recording on the cassette tape is prohibited. In this case,
the REC INH lamp on the front panel lights.
This selects the response when the mode is changed to
STOP/STILL while the tape is traveling.
QUICK
0:
Priority is given to the output picture.
1:
Priority is given to the response.
<Notes>
•
At the 1 (QUICK) setting, the picture may not be as clear in
the STOP/STILL mode as it would be at the 0 (NORMAL)
setting.
•
CTL may shift by 2 frames.
Description