Advertisement
Note on
10000 SL Inox
Thermal motor protector
Automatic deaerating valve
3. Initial Operation
Hose diameter
for 10000 SL Inox :
Hose diameter
for 18000 SP Inox :
a
b
7
Hose connection
7
of universal fitting
Hose connection
For 10000 SL Inox :
14
Sand and other abrasive substances cause increased wear and
reduce the pump's output.
Take care that the pump is located where the inlet openings at
the suction base are obstructed neither completely nor partly.
Stand the pump on a brick if using in a pond.
When you purchase your pump the swivel feet are set to the
flat suction position (1 mm).
v For normal operation, turn the feet 180° to 5 mm.
The pump is lifted 5 mm.
v Clear the outlet line before use.
The pump is automatically switched off on overheating by
the built-in thermal motor protector. After having cooled down,
the motor automatically switches on again (see 6. Trouble
Shooting).
The automatic deaerating valve eliminates any air pockets in
the pump. Air escapes by the vent bores
form under water. This is not a defect of your pump, but serves
to deaerate the pump.
It may take several seconds for the air to escape when the
pump is immersed for the first time.
4
13 mm (1/ 2 ")
15 mm (5 / 8 ")
19 mm (3 /4")
–
Cut off topmost
a
nipple at
The following connection kits are required for 13 mm to
19 mm connections:
13 mm (1/ 2 "): GARDENA Pump Connection Set, Art. No. 1750
25 mm (1")
38 mm (1 1/ 2 ")
Do not cut off
.
any nipples.
or GARDENA Tap Connector, Art. No. (2)902,
and GARDENA Standard Hose Connector,
Art. No. (2)915
4
and air bubbles
38 mm (1 1/ 2 ")
50 mm (2 ")
Cut off top two
b
nipples at
.
Advertisement
