Advertisement
5. Cleaning
Flushing the Pump :
Cleaning the suction
base and impeller :
8
9
6
9
6
6. Trouble-Shooting
Problem
Pump is running,
but doesn't deliver.
Pump doesn't start or
suddenly stops during
operation.
The pumps are virtually maintenance-free.
After having pumped chlorinated swimming pool water or other
liquids leaving residues, the pump should be rinsed with clear
water.
Warning ! Electric shock !
A
Risk of injury due to electric shock.
V Disconnect the pump from the mains before clean-
1. Only for 10000 SL Inox : Unscrew the Phillips screw
and pull the suction base cover
2. Unscrew the 6 Phillips screws
off the pump.
3. Clean suction base
0 A
if necessary.
4. Reinstall the suction base
5. Only for 10000 SL Inox : Insert the suction base cover
the suction base
8
Note for 10000 SL Inox :
It is often sufficient to simply remove the suction base cover
and clean the suction base cover
For safety reasons a damaged impeller
changed by the GARDENA Service Centre.
Probable cause
Air cannot escape, since
pressure line is closed.
Air locks in the suction base.
Impeller clogged.
When starting the pump,
water height falls below the
min. water level.
Thermal overload switch has
switched the pump off due
to overheating.
ing the suction base and impeller.
6
, impeller
6
and screw in the Phillips screws
6
and screw in the Phillips screw
0
off the suction base
8
and pull the suction base
9
and suction base cover
A
0
6
and suction base
9
can only be ex-
Remedy
v Open pressure line
(e.g. kinked pressure pipe).
v Wait for max. 60 seconds
until the pump deaerates
automatically over the vent
valve. If necessary, switch
off and start it again.
v Disconnect plug and clean
impeller (see 5. Cleaning).
v Submerge pump deeper.
v Disconnect plug and clean
impeller (see 5. Cleaning).
Observe max. media temper-
ature of 35 °C.
A
6
.
6
0
8
.
0
into
.
0
.
17
17
Advertisement
