Advertisement
3
5
Manual operation :
5
3
Only for 10000 SL Inox :
Flat suction /
Normal operation
8
16
Adjusting the Cut-in and Cut-out Height :
The maximum cut-in height and minimum cut-out height (see
8. Technical Data) can be adjusted.
v Press the cable of the float switch
switch lock
Do not select a cable length that is too long or short to ensure
that the float switch can turn on and off properly.
• The higher the opening of the float switch lock
the cut-in and cut-out height.
• The shorter the length of cable between the float switch
and the float switch lock
higher the cut-out height.
The cable length between the float switch
3
lock
must always be at least 10 cm.
The pump remains in constant operation because the float switch
is bypassed.
1
1. Push the float switch
cable downward.
2. Stand the pump on a firm surface
2
– or –
use a rope attached through the bore hole in the carrying
handle
3. Plug the power cable
The residual water height (approx. 1 mm for 10000 SL Inox /
40 mm for 18000 SP Inox) is only reached during manual opera-
tion since the float switch turns off the pump during automatic
operation before this water level is reached.
V If the water height is lower than 3.5 cm, fill the pump
before operation over the universal fitting
Flat suction :
v Turn the 3 swivel feet
180° to 1 mm.
Flat suction up to 1 mm.
The residual water level of approx. 1 mm is only reached during
flat suction in the manual operation mode. If the water level is
lower than 25 mm, you can accelerate flat suction by switching
the pump off and on 2 to 3 times.
3
.
3
, the lower the cut-in height and the
5
onto the float switch lock
2
to immerse the pump in a well or shaft.
1
into a mains socket.
8
5
into an opening in the float
3
, the higher
5
and the float switch
3
with the
7
with water.
Normal operation :
v Turn the 3 swivel feet
180° to 5 mm.
Flat suction up to 5 mm.
5
8
Advertisement
