Table of Contents
Advertisement
TELEPHONE:
FAX:
1) Burner assembly
2) Pan Support
3) Gas Tap Knob
4) Hotplate Tap
5) Oven Thermostat
6) Oven Door Seal
SERVICING/REPLACING PARTS 7013,P6BO AND P6BDO
BEFORE ANY MAINTENANCE ISOLATE FROM SUPPLY
1. HOB TAP
- Remove pan supports and fascia panel (2 screws on front).
Disconnect burner supply tube and thermocouple. Undo the 2 screws securing the tap
to the rail. Check sealing washer and replace if necessary. Assemble in reverse
order.
2. HOB BURNER/THERMOCOUPLE
Unscrew hexagonal headed mixing tube from centre of burner assembly on front and
rear burners. Burner body and spillage shield can now be lifted off. Disconnect
thermocouple from rear of tap. Undo locknut on burner mounting channel. Assemble in
reverse order.
3. OVEN THERMOSTAT Proceed as for hob tap and remove right hand side panel.
Slide thermostat phial from housing inside oven. Remove through hotplate well.
Assemble in reverse order.
4. OVEN THERMOCOUPLE Disconnect from thermostat. Remove right hand side
panel and slide out oven base. Undo locknut holding thermocouple to oven burner.
Remove through oven side panel and hotplate well. Assemble in reverse order.
5. OVEN BURNER/IGNITON Remove oven base. Disconnect oven supply tube, H.T.
lead and thermocouple. Burner is held in by 2 screws. Piezo spark generator is
secured by a locknut. Electrode secured to burner bracket by centre screw.
SERVICE (44) 01332 875665
SERVICE (44) 01332 875536
7) Piezo Spark generator
8) Electrode
9) Oven Burner
10) Oven Injector
11) Oven Thermocouple
12) Castors
Remove Pan Supports and Burner caps.
INSTRUCTION REF: IN151
ISSUE No.
2
DATE 10.02.04
Page 10 of 19
13)H.T Leads
14) Burner Baffle
15) Drip Tray
16) Duck rack
17) Thermocouple Valve
Advertisement
Table of Contents
