R100 Remote Control - Grundfos CRE Series Installation And Operating Instructions Manual

10.3 R100 remote control

The pumps are designed for wireless communication with the
Grundfos remote control R100.
Fig. 30 R100 communicating with the pump via infrared light
10.3.1 R100 menu structure
0. GENERAL
Switch off R100
Return to start
Delete all changes
Store settings
Call up settings
Store status data
Call up status data
18
1. OPERATION
Setpoint
Operating mode
Manual speed
Alarm
Warning
Alarm log 1 to 5
Warning log 1 to 5
During communication, the R100 must be pointed at the control
panel. When the R100 communicates with the pump, the
indicator light in the middle of the Grundfos Eye will flash green.
See page 36.
The R100 offers additional possibilities of setting and status
displays for the pump.
The displays are divided into four parallel menus:
0. GENERAL (see operating instructions for the R100)
1. OPERATION
2. STATUS
3. INSTALLATION.
See section
10.3.1 R100 menu
2. STATUS
Actual setpoint and
external setpoint
Operating mode
Actual controlled value
Analog input 1, 2 and 3
Pt100/1000 input 1 and 2
Speed
Power input and power
consumption
Operating hours
Replace motor bearings
structure.
3. INSTALLATION
Control mode
Controller
Signal relay 1 and 2
Buttons on pump
Number
Digital input 1 and 2, Function
Digital input/output 3 and 4, State
Digital input/output 3 and 4,
Function
Low-flow stop function
Analog input 1, 2 and 3, Function
Analog input 1, 2 and 3, Measured
parameter
Analog input 1, 2 and 3
Pt100/1000 input 1 and 2, Function
Pt100/1000 input 1 and 2, Measured
parameter
LiqTec function
Operating range
Ramps
Motor bearing monitoring
Motor bearings
Standstill heating