Operation Mode Established By Scene File Data (Scene Mode; Releasing The Scene Mode - Panasonic AJ-RC5 Operating Instructions Manual

Scene File Operations
Operation mode established by scene file data <scene mode>
In the scene mode established upon completion of the scene data saving or loading operations,
the KNEE SLOPE, KNEE POINT, DETAIL, GAMMA and M.PED VR control operations differ
slightly from their regular operations.
Regular operations:
Operations in scene mode: The data and control positions immediately after scene data saving
<Notes>
≥ Depending on the positions of the controls during saving and loading, the lower or upper limits of the
data variable ranges may be exceeded by the control variable ranges. In this case, when a particular
control is operated after saving or loading, its data will be changed as normal up to the lower or
upper limit, but the data will not change any further once the limit is exceeded. Furthermore, when a
particular control is stopped at the position where the lower or upper limit is exceeded, this stopped
position will serve as the position that indicates the lower or upper limit value.
≥ While the scene mode is established, the VTR operations can be performed by setting the
VTR/SCENE enable switch to REC ONLY or VTR ON just as with regular operations.

Releasing the scene mode

To release the scene mode, proceed as follows.
As soon as the regular operation mode has
been restored from the scene mode, the KNEE
POINT, KNEE SLOPE, DETAIL, GAMMA and
M.PED VR control item data changes to the
control position data which was established at
that point when the scene mode was released.
Furthermore, the data established during the
scene mode is used as is for all data with the
exception of the control data.
Example: Scene No.2 while the scene mode is
established
REW FF
S1 S2
STOP
PLAY
S3 S4
The selected scene No. button and LOAD
button are on.
The control positions are sent to the camera recorder as menu data
information.
or loading serve as the reference for operation. In the case of the
control data, the changes from the data immediately after saving or
loading are sent to the camera recorder.
All the button LEDs now go off.
START/STOP
<Notes>
≥ The scene mode is automatically released
SAVE
≥ The scene is also automatically released
REC CHK
LOAD
E-12
1 Press the LOAD button.
REW FF
S1 S2
STOP
PLAY
S3 S4
when the power of the camera recorder and
HEAD POWER switch on the base station are
turned off.
when the saving operation has failed and
there is no data to be loaded.
START/STOP
SAVE
REC CHK
LOAD