Table of Contents
Advertisement
Active VGA Out
Once the COMPUTER IN and COMPUTER OUT jacks have been properly connected
to the corresponding devices, select ON to generate VGA signal output. The projector
will only receive output signals via Computer In 1.
Active Audio Out
When the AUDIO IN jack is correctly connected to a device, select ON to output audio
signals.
Adjusting the sound
The sound adjusents made as below will have an effect on the projector speaker(s).
Please check that you have made a correct connection to the projector audio input /
output jacks. See
Adjustments in Audio Mode
1.
Open the OSD menu and enter Basic > Audio Settings > Audio Mode menu.
2.
Press / to select the primary Audio Mode.
If available, you may press the [Audio Mode] on the remote control to select the primary Audio mode.
Mute
1.
Open the OSD menu and enter Basic > Audio Settings > Mute menu.
2.
Press / and select ON.
If available, you may press the
ON or OFF.
Adjusting the sound level
1.
Open the OSD menu and enter Basic > Audio Settings > Volume menu.
2.
Press / to select the desired volume.
If available, you may press the
the projector.
Switch off the projector
1.
Press the
Power button. A confirmation message will be displayed on screen. The
message will disappear if you do not respond within a few seconds.
2.
Press the
Power button again.
3.
Disconnect the power cord from the wall socket if the projector will not be used in an
extended period of time.
"Connection"
for details.
button on the remote control to switch the projector audio
button on the remote control to adjust speaker volume of
38
Hide quick links:
Advertisement
Table of Contents
