Table of Contents
Advertisement
Selecting On outputs an audio signal when the AUDIO IN and AUDIO OUT sockets are
correctly connected to devices.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input/output jacks. See
"Connection" on page 14
Muting the sound
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Audio Settings > Mute menu.
2.
Press
/
If available, you can press
and off.
Adjusting the sound level
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Audio Settings > Audio Volume menu.
2.
Press
/
If available, you can press
level.
Shutting down the projector
1.
Press
Power and a confirmation message is
displayed prompting you.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
Power a second time.
3.
Disconnect the power cord from the wall
socket if the projector will not be used in an
extended period of time.
CAUTION
•
To protect the lamp, the projector will not respond to any commands during the cooling
process.
•
To shorten the cooling time, you can also activate the Quick Power Off function. See
"Quick Power Off" on page 37
•
Do not unplug the power cord before the projector shutdown sequence is complete.
for more details.
to select On.
on the remote control to toggle the projector audio between on
to select a desired sound level.
or
on the remote control to adjust the projector's sound
for details.
31
Advertisement
Table of Contents
