Table of Contents
Advertisement
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
SOURCE > Standby Settings, and the cable connections are correctly made. For the
connection methods, see the
Active VGA Out
Selecting On outputs a VGA signal when the COMPUTER IN 1 and COMPUTER OUT
sockets are correctly connected to devices. The projector outputs the signal received only
from COMPUTER IN 1.
Active Audio Out
Selecting On outputs an audio signal when the AUDIO IN and AUDIO OUT sockets are
correctly connected to devices.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input/output jacks. See
"Connection" on page 15
Muting the sound
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Audio Settings > Mute menu.
2.
Press
/
If available, you can press
and off.
Adjusting the sound level
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Audio Settings > Audio Volume menu.
2.
Press
/
If available, you can press
level.
Turning off the Power On/Off Ring Tone
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Power On/Off Ring Tone menu.
2.
Press
/
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Connection
chapter.
for more details.
to select On.
on the remote control to toggle the projector audio between on
to select a desired sound level.
or
on the remote control to adjust the projector's sound
to select Off.
35
Advertisement
Table of Contents
