Before Requesting Help - Panasonic KX-TG2650N Operating Instructions Manual

Before Requesting Help

Problem
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
The unit does not work.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or the base
unit do not ring.
The handset display is
blank.
The handset display is still
blank after pressing
or .
Ü á
60
•You are too far from the base unit. Move
closer and try again.
•Place the handset on the base unit and
try again.
•Plug in the AC adaptor.
•Extend the handset antenna fully.
•Raise the base unit antennas.
•Check the settings (p. 10–14).
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 12).
•Install the battery properly (p. 58).
•Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
•Re-install the battery within 3 minutes to
avoid memory loss and place the
handset on the base unit. Try again.
•Locate the handset and the base unit
away from other electrical appliances
(p. 3).
•Move closer to the base unit.
•Extend the handset antenna fully.
•Raise the base unit antennas.
•Press
channel.
•The ringer volume is set to OFF. Set to
HIGH or LOW (p. 17).
•The handset is in the standby mode
(p. 9). Press
the display on.
•Charge the battery fully (p. 11).
, ,
Ö Ñ
Remedy
(FUNCTION/CH)
, ,
Ö Ñ Ü
to select a clearer
or to turn
á