Installation Instructions; Wall Mounting - Siemens DH18100 Installation And Operating Instructions Manual

The mixer and the warm water pipe may
be hot. Please inform and instruct children
appropriately.
Do not use aggressive or abrasive cleaning
detergents!
Congratulations on purchasing this Siemens appliance. You
have acquired a top-quality product, which will give you a lot
of enjoyment.
Please read this installation and operating instruction
manual carefully, then act accordingly! Store for future
reference.

Installation instructions

Install the continuous-flow heater as described in the
illustrated section. Observe the instructions in the text.
The illustrations can be found in the centre of the instruction
manual.
Installation
List of items supplied
I.
1 Continuous-flow heater
2 Installation template
3 Connection piece for hot water
4 Washer, red Ø 15 mm
5 Connection piece for cold water
6 Washer, Ø 24 mm
7 Mounting bolt
8 Wall plug
9 Securing nut
10 Threaded bushing
11 Cable grommet

Wall mounting

II.
There are two ways in which the continuous-flow heater can
be mounted on the wall:
– Using the mounting bolt. Unevenness in the wall up to a
depth of 25 mm can be compensated for.
– Making use of the holes that were drilled for the old heater:
Use the mounting template to establish whether the exist-
ing holes line up properly.
10
en
Do not use a steam cleaner.
The appliance is only to be descaled by a
suitably qualified specialist.
The following describes the installation procedure using the
mounting bolt.
Marking the point for mounting the heater and selecting
the opening for the connecting cable (Fig. A)
Important!
Make sure that the connecting cable is isolated
from the mains electricity supply!
Place hole 3 in the mounting template over the cold-water
inlet.
Select the most suitable hole through which the con-
necting cable is be fed. The connecting cable must pass
through one of the six holes marked 14... Terminal
BZ 45Z20 can be used if the cable is fed into the water
heater through one of the bottom holes marked 14a.
Mark the point 12 at which the mounting bolt is to be
inserted.
Fitting the mounting bolt and attaching the pipe
connecting pieces (Fig. B)
Open up the heater (Fig. C)
Punching out the holes at the rear of the heater for the
mounting bolt and the connecting cable
Important: When mounting the appliance, only the holes
actually required should be punched out. Any other holes
that are not going to be used must be sealed watertight.
Inserting the connecting cable (Fig. D)
Push the grommet 11 over the end of the connecting
cable.
Note: Do not use the grommet for a cable with a cross-sec-
tion of 16 mm 2 . The appliance must then be installed flush
with the wall.
Attention: Without a grommet, the DH18100/21100/24100
is splashproof only (IP 24).
Place the heater over the connecting cable.
Press the grommet into the hole in the rear wall of the
heater through which the cable should be fed. Ensure that
the edges of the grommet are flush with the hole all the
way round.
Fit the heater onto the threaded bushing 8 and secure it
in place with the nut 9.
Compensating for unevenness in the wall (Fig. E)