Installation Instructions - Siemens 9001155296 Installation And Operating Instructions Manual

Congratulations on purchasing this Siemens ap-
pliance. You have acquired a top-quality product,
which will give you a lot of enjoyment.
Please read this installation and operating in-
struction manual carefully, then act accordingly!
Store for future reference.

Installation instructions

Install the water heater as described in the
illustrated section. Observe the instructions in
the text.
The illustrations can be found in the centre of the
instruction manual.
Installation
I.
Parts supplied
II.
Preparations for installation
Leave a gap of at least 30 cm above the top edge
of the appliance housing.
min. 30 mm
The water heater must be mounted so that it is
absolutely perpendicular. Use a standard pipe
joining piece to compensate for an uneven wall
surface (Fig. VI, 2).
For an additional water connection, use a stand-
ard 50 mm branch adapter (Fig. VI, 3).
en
max. Liter
5
4
3
2
1
min.
100°C.
Check the length of the mains connecting cable.
If necessary, fit a longer cable to heater before it
is mounted on the wall (Fig. V).
Attention!
Unplug the heater from the electricity
supply before changing the cable!
Installation of the mixer tap (Fig. II, 1–3).
Detach the mounting plate from the appliance.
Break off the template "S" (Fig. II, 4).
Hold the template against the mounting plate
and place it over the mixer tap (Fig. II, 5).
Mark the position of the holes for mounting the
plate (Fig. II, 6).
Note: Make sure that the mounting plate is
absolutely horizontal!
Any holes in the wall and rawlplugs that remain
from a previous water heater can be used again.
Simply identify the corresponding holes in the
mounting plate.
If the previous water heater was a Siemens
BK0562, bend strap "L" outwards and use the
existing holes and rawlplugs (Fig. II, 7).
III.
Wall mounting
Fixing the mounting plate (Fig. III, 1).
Insert mains cable "A" into the recess – towards
right or left – depending on position of socket
(Fig. III, 2).
Hook the heater onto the mounting plate
(Fig. III, 3).
Attach and tighten the water intake and outlet
pipes (Fig. III, 4).
Insert the overflow pipe (Fig. III, 5).
IV.
Setting the water flow rate
The maximum water flow rate is 10 l/min, i. e. 1 litre
of water takes 6 seconds to flow into the tank.
Open tap "G" fully.
Adjust the flow rate by turning throttle screw
"D" on the underside of the mixer unit (1/2 turn
max.).
13