First Time Start-Up Of The Set Top Box - Optus DHR 4901 OPT User Manual

7 First time
start-up of the
Set Top Box
After installing all the cables correctly between the Satellite Dish, Set Top Box and the
TV, there are six easy steps to perform before you can activate the Set Top Box with
your network provider.
See the following list below for the initial set-up procedures:
• Remote Pairing
• Resolution
• Display Format
• Time Zone
• Satellite Channels Search
• Check the quality of your Dish Installation
Setup Procedures
Switch ON the TV and set it to the correct TV channel and then switch ON the
Set Top Box, after a few seconds the splash screen will appear followed by the first
installation screen.
Note:
IR Mode: The remote will operate in in IR mode (Default Mode) before pairing.
The remote shall require direct visual access between remote and Set Top Box.
When in IR Mode the remote red LED will light up when a key is pressed.
RF Mode: The remote will operate in RF4CE mode after pairing. The remote shall
operate without direct visual access between remote and Set Top Box.
When in RF Mode the remote green LED will light up when a key is pressed.
17