Sway Command™ Light Pod Mounting - Lippert Components Sway Command Install Manual

Sway Command™ Light Pod Mounting
NOTE: The Light Pod (Fig. 5A)should be mounted in a location that can be easily seen by the tow vehicle
operator.
1. Connect the Light Pod to the extension harness (Fig. 5C) that was previously connected to the Sway
Command™ main harness.
2.
Determine the proper mounting location for the Light Pod.
3. Attach the Light Pod to the trailer wall with two #8 x 1 screws (Fig. 5B).
NOTE: Be sure to seal any wall penetrations to prevent water infiltration.
Rev: 09.17.2015
Fig. 5
A
B
B
A C
Page 5
Sway Command™ OEM Install Manual