Alarm - Panasonic KX-TGM430 Operating Instructions Manual

Programming
*12 This setting is available when you have the key detector (KX-TGA20). Read the installation
manual for more information on the key detector.
*13 For models with supplied key detectors, the display shows "1: Detector1".
*14 If you register 2 or more key detectors.
*15 If you subscribe to a Caller ID service and want to view the caller's information after lifting up
the handset to answer a call, turn off this feature.
*16 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary. The setting should stay at "700 ms" unless pressing MFLASHN fails to
pick up the waiting call.
*17 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to "A" if telephone line condition is not good.

Alarm

An alarm sounds at the set time for 1 minute
and repeats 5 times at 5 minute intervals
(snooze function). You can also configure the
alarm to display a text memo. You can set 3
separate alarms for each handset. Each alarm
can be set to sound once, daily, or weekly.
When an alarm sounds, the message indicator
flashes rapidly if the handset message
indicator's "Alarm" setting is enabled
(page 31).
Important:
R Make sure the unit's date and time setting
is correct (page 24).
1
MMENUN#720
2
MbN: Select the desired alarm. a
MSELECTN
3
MbN: Select the desired alarm option. a
MSELECTN
"Off"
Turns alarm off. Go to step 10.
"Once"
An alarm sounds once at the set time.
"Daily"
An alarm sounds daily at the set time.
Go to step 5.
"Weekly"
Alarm sounds weekly at the set time(s).
For assistance, please visit http://shop.panasonic.com/support
60
TGM43x(en)_0426_ver031.pdf
4
5
6
7
8
9
10
Note:
R Press MSTOPN to stop the alarm completely.
R When the handset is in use, the alarm will
R Press any dial key or MSNOOZEN to stop
R If you want to make an outside call when
60
Proceed with the operation according to
your selection in step 3.
n Once:
Enter the desired month and date. a
MOKN
n Weekly:
MbN: Select the desired day of the week
and press MSELECTN. a MOKN
Set the desired time.
*: Select "AM" or "PM". a MOKN
Enter a text memo (10 characters max.).
a MOKN
MbN: Select the desired alarm tone. a
MSELECTN
R If you select one of the ringers
("Ringer 1" to "Ringer 5"), select
the desired frequency ("Frequency
1" to "Frequency 6").
R We recommend selecting a different
ringer tone from the one used for
outside calls and intercom calls.
MbN: Select the desired snooze setting.
a MSAVEN
MSELECTN a MOFFN
not sound until the handset is in standby
mode.
the sound but keep the snooze function
activated.
the snooze function is activated, please
2016/04/26 10:55:19