Asus B150I PRO GAMING User Manual page 70

Allow Fan Stop [Disabled]
This item allows the fan to run at 0% duty cycle when the temperature of the source is
dropped below the lower temperature.
Configuration options: [Disabled] [Enabled]
Water Pump Control [Disabled]
[Disabled]
[DC Mode]
[PWM Mode]
The following items appear only when you set the Water Pump Control to [DC mode] or
[PWM Mode].
Water Pump Upper Temperature [70]
Use the <+> or <‑> keys to adjust the upper limit of the water pump temperature.
The values range from 25 to 75.
Water Pump Max. Duty Cycle (%) [100]
Use the <+> or <‑> keys to adjust the maximum water pump duty cycle. The values
range from 20% to 100%. When the CPU temperature reaches the water pump
upper temperature limit, the water pump will operate at the maximum duty cycle.
Water Pump Middle Temperature [25]
Use the <+> or <‑> keys to adjust the middle limit of the water pump temperature.
The values range from 20 to 75.
Water Pump Middle Duty Cycle (%) [20]
Use the <+> or <‑> keys to adjust the middle water pump duty cycle. The values
range from 20% to 100%. When the CPU temperature reaches the water pump
middle temperature limit, the water pump will operate at the middle duty cycle.
Water Pump Lower Temperature [20]
Use the <+> or <‑> keys to adjust the lower limit of the water pump temperature.
The values range from 0 to 75. The water pump will operate at the minimum duty
cycle when the temperature is lower than the limit.
Water Pump Min. Duty Cycle(%) [20]
Use the <+> or <‑> keys to adjust the minimum water pump duty cycle. The values
range from 20% to 100%. When the CPU temperature is under the limit, the water
pump will operate at the minimum duty cycle.
2.7.5 Anti Surge Support [On]
This item allows you to enable or disable the Anti Surge function.
Configuration options: [On] [Off]
2‑34
Disable the Water Pump control feature.
Enable the Water Pump control in DC mode for 3‑pin chassis fan.
Enable the Water Pump control in PWM mode for 4‑pin chassis fan.
Chapter 2: BIOS Setup