Download  Print this page

Pioneer SGY-PM90 Quick Manual page 5

Power meter
Hide thumbs

Advertisement

Mode Switching – Non-Pioneer Computer Users
Single Leg and Dual Leg ANT+ Modes
Switching Left and Right Sensors FROM Dual Leg to Single
• Notes
• This method is for users who wish to separate a dual leg system and use single
leg crank arms . Ie. 2 different bikes.
• The following method is for ANT+ Cycle Computer users who do NOT have a
Pioneer Cycle Computer – See slide 5 for Mode Switching with a Pioneer
Computer
• Dual Leg Ultegra SGY68-Series, DuraAce SGY90-Series completed cranksets
and SGY-PM9100C "Kits" ship pre-set in the Dual ANT+ Mode.
• To confirm Dual Leg ANT+ Mode, remove and replace the batteries, you should
see a SOLID Orange light on both the Left and Right Sensors.
Switching to Single Leg Mode
1. Spin the crank 3 – 4 rotations to activate the Power Meter
2. Press the push switch for 3 seconds and release
3. Both sensors should blink orange for 10 seconds
Leg Mode
Switching Left and Right Sensors FROM Single Leg to Dual
• Notes
• This method is for users who are upgrading from a single leg sensor with a
second Left or Right leg sensor.
• The following method is for ANT+ Cycle Computer users who do NOT have a
Pioneer Cycle Computer – See slide 5 for Pioneer Mode Switching with a
Pioneer Computer
•Single Leg Ultegra SGYLT68-Series, DuraAce SGY-LT90-Series, and SGY-
PMRTC "Kits" ship pre-set in the Single Leg ANT+ Mode.
• To confirm Single Leg ANT+ Mode, remove and replace the battery, you
should see a BLINKING Orange light.
Switching to Dual Leg ANT+ Mode
1. Spin the crank 3 – 4 rotations to activate the Sensors
2. Press the Push Switch for 3 seconds and release
3. Confirm both sensors are blinking
4. While blinking, press and hold the push switch for 3 more
seconds and release
5. To confirm you have switched to Dual Leg, remove the
batteries and replace, you should see a solid orange light
on both sensors
Leg Mode

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgy-pm68