Download  Print this page

Pioneer SGY-PM90 Quick Manual page 15

Power meter
Hide thumbs

Advertisement

Mode Switch & FW Update Conditions
Right LED
Left LED
L, R or L&R Green
Pedaling Mode
Solid Orange
Solid Orange
Dual ANT+
Factory
Blinking Orange
Blinking Orange
Single ANT+
Single ANT+
Factory
Solid Orange
Blinking Orange
Dual ANT+
Single ANT+
Blinking Orange
Solid Orange
Single ANT+
Blinking Green
Blinking Red
Solid Red
*
Before Mode Switching, the ANT+ Transmit feature must be off - Menu / Settings / Device
Standard Factory Setting Possibilities
Right Side Push Button
Puts Dual L&R into Single ANT+ Modes
Dual ANT+
Pull Batteries and Replace, Spin Crank,
Factory
Hold push button for 3 Sec then release – pg. 23 OM
Puts Single L& Single R into Dual ANT+ Mode
Kit Upgrade from Single to Dual
Pull Batteries and Replace, Spin Crank, Hold push button for 3
Factory
Sec. release, right blinks green then fast flashing orange, Press 3
Sec again while flashing fast orange then release – pg. 19 OM
Rare, Required a SGX-CA500 to switch the Left Leg to Single
when right side was not in range or battery out leaving Right in
Rare, Required a SGX-CA500 to switch Right Leg to Single while
Dual ANT+
left leg was out of range or battery out leaving Left In Dual
Right Side, Left Side Sensor in unknown Dual Mode
Separated System Firmware update not completed
N/A
Sensors are in Pedaling Mode
Push Button has no function
Use on 2 bikes / cranks
N/A
Dual
N/A
N/A
N/A
N/A
Damaged, Send for Service
SGX-CA500
Mode Switch L, R, or L&R to Single or
Dual ANT+
Will Update Sensors to Latest firmware
Mode Switch L, R, or L&R to Single ANT+
or Pedaling Monitor
Mode Switch L, R, or L&R to Dual ANT+
or Pedaling Monitor
Mode Switch Both L&R to Dual or Single
ANT+ To Re-Sink Pair
Right side is in ANT+ Single but must
Mode switch right into ANT+ Single again
to erase last dual Pairing. Then Mode
switch both to desired Mode
Sensor(s) are in Update Mode. Must complete FW Update
Move away from Wifi Interference
N/A
N/A
Service Situation
FW Updater tool
N/A
Sensors must be in ANT+
Mode
Enter Ant ID's into L & R
Enter Ant ID's into L, R or
L & R
Both must be in same
ANT+ Mode
N/A
Both must be in same
ANT+ Mode
N/A
N/A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgy-pm68