Download  Print this page

Pioneer SGY-PM90 Quick Manual page 4

Power meter
Hide thumbs

Advertisement

Easy Installation Power Meter Cranksets
SGY-PM90 and SGY-PM68 with Pioneer Cycle Computer
• Magnet Placement
1. Measuring from the center of the bottom bracket out, temporarily tape the magnet so that the center line
of the magnet is:
Right Drive Side - 42mm
Left Side - 53mm
2. Use the supplied Magnet Placement Template to help locate the optimum locations for magnet placement
on the frame.
3. Position the magnets so the sensor line and magnet center line are parallel when the sensor passes over.
• Mode Selection & Pairing to the Pioneer Computer
1. Spin the crank 3 – 4 rotations to activate the Power Meter
2. Pressing Pedaling Monitor will search sensor ID or local crank.
Press Menu
Press Option
• Magnet Calibration
Press Option
Press Pedaling Settings
Press Menu
1.
Spin the crank FORWARD slowly (30 rpm) until both left
and right sensors detect magnets at least 5 times for each
side and press Save.
2.
Secure magnets for final placement.
Press Pedaling Settings
Press Mode Switch
Press Magnet Calibration
Press Start calibration
Spin Crank Slowly Forward
Confirm 5 x per side
Press Save
Left Sensor Arm
ID 12345
Sensor
ID
Magnet Range
1.5mm –
10.7mm
Check Left & Right, Enter ANT+ ID,
Press Pedaling Monitor
Press OK
• Zero Calibration – Position Left or Right crank arm to the 6 o'clock position
Press Menu
For additional Installation Instructions visit the following on-line support locations
www.pioneerelectronics.com/PUSA/Cycle+Sports/Products/Power+Meters
www.Youtube/Pioneer Cycle Sports USA
Please refer to the owners manual for detailed installation instructions.
Visit
https://cyclo-sphere.com/
Customer Support – 1-800-421-1624
E-Mail: cycle-sports@pioneer-usa.com
Press OK
Center Magnet Placement Template hole on bottom bracket
and use supplied double sided tape to temporarily secure while
locating optimum magnet location.
Sensor Line:
SGX-CA500 firmware must be 20150501.02.43 or higher.
Press Option
Press Pedaling Settings
Press Magnet Calibration
for the latest firmware and updates.
Magnet
Center
Magnet Template
Line:
card
Press OK

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgy-pm68