Download  Print this page

Pioneer SGY-PM90 Quick Manual page 3

Power meter
Hide thumbs

Advertisement

Easy Installation Power Meter Cranksets
SGY-PM90 and SGY-PM68 with Non-Pioneer ANT+ Cycle Computer
1.) Magnet Placement (Optional)
Measuring from the center of the bottom bracket out,
temporarily tape the magnet so that the center line of the
magnet is:
Right Drive Side - 42mm
Left Side - 53mm
Use the supplied Magnet Placement Template to help locate
the optimum locations for magnet placement on the frame.
Position the magnets so the sensor line and magnet center
line are parallel when the sensor passes over.
2.) Confirm Magnet Placement
Remove and replace both Left and Right batteries. Orange light will appear for 10 seconds.
Rotate the crank slowly (30rpm). Check that the LED on each sensor lights green once for each
revolution.
Once confirmed, secure magnets for final placement.
3.) Pair to your ANT+ Computer
Spin the crank 3 – 4 rotations to activate the Power Meter
See your ANT+ Cycle Computer
Instructions for Power Meter Pairing and
Zero Calibration procedures.
Sensor Line:
Magnet
Center
Line:
Left Sensor Arm
ID 12345
Sensor ID
Magnet Range
1.5mm – 10.7mm
Center hole on bottom bracket and use supplied
double sided tape to temporarily secure while locating
optimum magnet location
Magnet Template
card
For additional Installation Instructions visit the following on-line support
locations
www.pioneerelectronics.com/PUSA/Cycle+Sports/Products/Power+Meters
www.Youtube/Pioneer Cycle Sports USA
Please refer to the owners manual for detailed installation instructions.
Visit
Customer Support – 1-800-421-1624
E-Mail: cycle-sports@pioneer-usa.com
LED's light green
If no
Green
LED,
check and adjust
magnet placement
https://cyclo-sphere.com/
for the latest firmware and updates.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgy-pm68