Chapter 15 System Remote Management
15.4 Telnet
You can configure your NWA/WAC for remote Telnet access.
15.5 Telnet Commands
The following table describes the commands available for Telnet. You must use the
command to enter the configuration mode before you can use these commands.
terminal
Table 50 Command Summary: Telnet
COMMAND
[no] ip telnet server
[no] ip telnet server port <1..65535>
show ip telnet server status
15.5.1 Telnet Commands Examples
This command displays Telnet settings.
Router# configure terminal
Router(config)# show ip telnet server status
active
port
service control:
No.
Zone
========================================================================
Router(config)#
15.6 Configuring FTP
You can upload and download the NWA/WAC's firmware and configuration files using FTP. To use
this feature, your computer must have an FTP client.
84
: yes
: 23
Address
DESCRIPTION
Allows Telnet access to the NWA/WAC CLI. The
command disables Telnet access to the NWA/WAC CLI.
Sets the Telnet service port number. The
resets the Telnet service port number back to the factory
default (23).
Displays Telnet settings.
Action
NWA/WAC Series CLI Reference Guide
configure
no
command
no