Cli Modes - ZyXEL Communications nwa series Reference Manual

1.5 CLI Modes

You run CLI commands in one of several modes.
Table 2 CLI Modes
What User users
can do
What Limited-
Admin users can
do
What Admin
users can do
How you enter it
What the prompt
looks like
How you exit it
See Chapter 6 on page 41
look at (but not run) the available commands in User mode, and log out. Limited-Admin users
can look at the configuration in the web configurator and CLI, and they can run basic diagnostics in
the CLI. Admin users can configure the NWA/WAC in the web configurator or CLI.
At the time of writing, there is not much difference between User and Privilege mode for admin
users. This is reserved for future use.
NWA/WAC Series CLI Reference Guide
USER PRIVILEGE
• Look at (but not Unable to access
run) available
commands
• Look at system • Look at system
information (like information (like
Status screen) Status screen)
• Run basic • Run basic
diagnostics diagnostics
• Look at system • Look at system
information (like information (like
Status screen) Status screen)
• Run basic • Run basic
diagnostics diagnostics
Log in to the NWA/ Type enable in User
WAC mode
Router> Router#
Type exit Type disable
for more information about the user types. User users can only log in,
Chapter 1 Command Line Interface
CONFIGURATION SUB-COMMAND
Unable to access Unable to access
Unable to access Unable to access
• Configure simple • Configure
features (such as complex parts
an address (such as an
object) interface) in the
NWA/WAC
• Create or remove
complex parts
(such as an
interface)
Type configure Type the command
terminal in User or used to create the
Privilege mode specific part in
Configuration
mode
(varies by part)
Router(config)#
Router(config-
if-brg)#
...
Type exit Type exit
17