Makita DUR364L Instruction Manual page 9

Remaining battery capacity indication
Battery indicator status
Blinking
On Off
015452
Power switch action
WARNING:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
switch that does not actuate properly can lead to loss
of control and serious personal injury.
1
015382
Press and hold the main power button for some
seconds to turn on the tool.
To turn off the tool, press and hold the main power
button again.
2
015388
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
To start the tool, grasp the rear handle (the lock-off lever
is released by the grasp) and then pull the switch trigger.
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
Operating a tool with a
1. Main power
button
1. Lock-off lever
2. Switch trigger
1
To stop the tool, release the switch trigger.
NOTE:
The tool is automatically turned off after the tool is
•
left one minute without any operations.
Speed adjusting
1
015382
You can adjust the tool speed by tapping the main
power button.
Each time you tap the main power button,
or indicator lights up.
for low speed.
Reverse button for debris removal
WARNING:
Switch off the tool and remove the battery
•
cartridge before you remove entangled weeds
or debris which the reverse rotation function
can not remove. Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
015383
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris
entangled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
NOTE:
During the reverse rotation, the tool operates only
•
for a short period of time and then automatically
stops.
9
1. Main power
button
indicator
is for high speed and
1. Reverse button
1