Connect Electrical Wiring - Ortech OD-5006 User Manual

Ventilation fan

Hide thumbs

Table of Contents

ASSEMBLY INSTRUCTIONS

2. MOUNT WITH HANGER BARS

Insret the hanger bars into the slots in the housing. Place the fan

housing between the joists, make sure the bottom of the housing

is even with the finished ceiling. Extend the hanger hars to the

joist. Use screws to secure the hanger bars to the

ceiling joists.

3. ATTACH DAMPER/DUCT CONNECTOR

Snap the damper/duct connector onto the fan housing. The

connector must be flush with the top of the housing, and the

damper flap should fall closed.

4. INSTALL ROUND DUCTWOTK

Connect the round ductwork (not included) to the damper/duct connector,

and run the ductwork to a roof or wall cap (not included). Using tape (not

included), secure all the ductwork connections so that they are air tight.