Advertisement
Compact Series
MODEL
ODD-100MS + LED
INSTALLATION GUIDE
Connect Electrical Wiring
Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house
wiring to the wiring plate. Refer to the wiring diagram below, and connect the wires as shown.
Install Grille
Install ceiling material to complete the ceiling construction. Then, cut
around the fan housing. Insert the sensor plug into the plug base on
the power box first, and then install the grille.
To attach the grille assembly to the fan housing, pinch the grille springs
on the sides of the grille assembly and position the grille into the
housing with the grille springs in the appropriate slots. Push the grille
assembly towards the ceiling to secure.
Service Parts
WARNING
Ensure that the fan is switched off from the supply
WARNING
mains before replacing
info@ortechindustries.com
www.ortechindustries.com
* Blower Assembly includes
*
* Replacement Installation:
*
*
*
*
*
13376 Comber Way
375 Admiral Blvd
Mississauga
Surrey BC V3W 5V9
part 3, 4, 5, 6, 7, a, b
Remove the screw (part a),
then take out the blower
assembly from the
housing (part 8). Replace
the broken parts.
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474
Advertisement
