12.
80
Chapter 4 Removal and replacement procedures
Downloaded from
www.Manualslib.com
If it is necessary to replace the display bezel or any of the display assembly internal
components:
a.
Remove the four rubber screw covers (1) and the four Torx T8M2.5×5.0 screws (2) that
secure the display bezel to the display assembly.
NOTE:
The rubber screw covers on the display bezel top edge are thicker than the rubber
screw covers on the display bezel bottom edge.
b.
Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge
(3) of the display bezel until the bezel disengages from the display enclosure.
manuals search engine
ENWW