When Operating The Printer - Epson PLQ-30 User Manual

When loading paper
❏ Use passbooks and paper that have more than 60% reflectance.
❏ When you use a passbook, set Passbook mode to On and set Binding mode to the method for the
passbook's binding in the default setting mode.
❏ Do not load passbooks that are creased or have ripped seam.
❏ Do not use a passbook that has any metallic parts such as staplers or metal clips.
❏ Do not use a passbook with sticky parts such as stamps or seals.
❏ Do not use a passbook that has any pages smaller than the cover page.
❏ Do not print on the front or back cover of a passbook. Printing can be done only when the
passbook is opened.
❏ When you use paper that is shorter than 110.0 mm, set the paper eject direction to front. The
factory set default is front. Please access http://www.epson.com for information.
❏ Do not insert paper that is curled or has been folded into the slot when you load it.
❏ Do not punch holes in the area from 25.0 to 40.0 mm from the left edge of paper.
❏ Always use the printer with the ribbon cartridge installed. Otherwise, paper jam may occur.

When operating the printer

❏ Avoid using or storing the printer in places subject to rapid changes in temperature and humidity.
Keep it away from direct sunlight, strong light, heat sources or excessive moisture or dust.
❏ Adjust only those controls that are covered in the user documentation. Improper adjustment of
other controls may result in damage requiring extensive repair by a qualified technician.
❏ Whenever you turn off the printer, wait at least five seconds before turning it back on; otherwise,
you may damage the printer.
❏ Do not turn off the printer while it is printing the self test. Always press the Offline button to stop
printing and then turn off the printer.
❏ Do not turn off the printer while it is printing the hex dump. Always press the Offline button to
pause printing. Then turn off the printer.
❏ Do not reconnect the power cord to an electrical outlet that has the wrong voltage for your printer.
❏ Never replace the print head yourself; you may damage the printer. Also, other parts of the printer
must be checked when the print head is replaced.
PLQ-30/PLQ-30M User's Guide
Safety Instructions 12