Specifications - Stihl MSA 160 T Instruction Manual

Specifications

Battery
Type: Lithium-ion
Designation: AP, AR
The machine may be operated only with
original STIHL AP and AR rechargeable
batteries.
Power tool running time is dependent on
the energy content of the battery.
Chain Lubrication
Fully automatic, speed-controlled oil
pump
Oil tank capacity: 105 cc (0.105 l)
Weight
MSA 160 T:
without battery,
without cutting attachment:
without battery,
with 25 cm cutting attachment: 2.2 kg
without battery,
with 30 cm cutting attachment: 2.3 kg
Cutting Attachment
Actual cutting length may be less than
the specified length
MSA 160 T
Rollomatic E Mini 1/4" Picco guide bars
Cutting length:
Pitch:
Groove width:
Nose sprocket:
1/4" Picco chain
Picco Micro 3 (71 PM3) Type 3670
Pitch:
Drive link gauge:
Chain sprocket
7-tooth for 1/4" P
Max. chain velocity to
ISO 11681:
As a rule, the mean chain velocity in
operation is about 20% lower than the
maximum chain velocity in accordance
with ISO 11681. Contact your STIHL
servicing dealer for advice on personal
protective equipment.
Sound and vibration levels
Sound and vibration levels are
1.9 kg
determined on the basis of the operating
status at nominal maximum speed.
For further details concerning
compliance with the Physical Agents
Directive Vibration 2002/44/EEC, see
www.stihl.com/vib/
Sound pressure level L
EN ISO 22868
MSA 160 T:
Sound power level L
MSA 160 T:
Vibration level a
25, 30 cm
1/4" P (6.35 mm) MSA 160 T: < 2.5 m/s
1.1 mm
The K-factor in accordance with
8-tooth Directive 2006/42/EC is 2.5 dB(A) for
the sound pressure level and sound
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
for the vibration measurement.
1/4" P (6.35 mm)
The vibration values quoted above have
1.1 mm
been measured according to a
standardized test procedure and may be
used to compare electric power tools.
Depending on the type of usage, the
vibrations that actually occur may differ
11.5 m/s
from the values quoted.
The vibration values quoted may be
used for an initial assessment of the
user's exposure to vibrations.
The actual exposure to vibrations has to
be evaluated. This process may also
take into account times during which the
electric power tool is switched off and
times during which it is switched on but
running without load.
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
to
p
by road transport to the place where the
machine is to be used without additional
requirements.
81 dB(A)
The lithium ion batteries included are
to EN ISO 22868
w
subject to the provisions of the
legislation relating to dangerous goods.
93 dB(A)
English
to EN ISO 22867
hv
Handle, left Handle, right
2 2
< 2.5 m/s
2
75