Wen APEX Pro 3710 Operator's Manual page 19

Installing the anti-kickback device
(Figure 18)
While pulling out the attachment pin, attach the
Anti-Kickback Device into the flat recessed area A
of the riving knife (Figure 18).
Slide the Anti-Kickback Device down until it drops
into the recessed area – then release the attachment
pin such that the Anti-Kickback Device locks onto
the riving knife immediately behind the guard
assembly. Check that the attachment pin is securely
connected into locking hole.
Carefully raise and lower the pawls – when letting
go, the spring-loaded pawls must come down and
contact the table insert (Figure 18).
Note: The two installing are independent of each other, so the Anti-Kickback Device can be attached
before the Blade Guard.
19