Table of Contents
Advertisement
REMOTE CONTROLS - INSTALLATION
n FIll-lNG THE MASTER CONTROL
K-31 -A
0 Determine the most suitable
position for the Control.
0 Make 3 holes in the wall, as
shown, one for the cable and two
for the securing
screws. Make sure
holes are level. Fit wall plugs (fig 1).
0 Run the cable provided
between
the Control and the Infinity 20, or
refer to page 14, No. 8.
If you haven't already done so, cut
the lugs off the cotrnecting
wire.
0 Remove the faceplate from the
Remote Control using a screwdriver
(fig 2).
0 Using the BC-31-A Control
adaptor and the connectors
provided, connect the Remote
Control to the cable (fig 3).
0 Fix the Control to the wall, and
replace the faceplate (fig 4).
Outline of Remote
Control
195
(fig 1)
8
(fig
2)
To Control
Remote
Ezlx!L--
ZY
Cable Adaotor
Connectors
(fig 3)
T
F&e
Plate
(fig 4)
-16-
Advertisement
Table of Contents
