Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for IBASE Technology FWA6304-D25
Summary of Contents for IBASE Technology FWA6304-D25
- Page 1 FWA6304-D25 Network Appliance User s Manual Version 1.0...
-
Page 2: Table Of Contents
Chapter 6 Installing CompactFlash Card ..................12 Chapter 7 Installing Memory Module ....................13 Installing 2.5” SSD ......................14 Chapter 8 Chapter 9 Installing Mini PCI-e Module ..................15 Chapter 10 Lock Power Connector ....................15 FWA6304-D25 Series User’s Manual... - Page 3 4. Do not operate the processor without a thermal solution. Damage to the processor can occur in seconds. 5. Do not block air vents at least minimum 1/2-inch clearance required. In case explosion, you should change battery with same specification. FWA6304-D25 Series User’s Manual...
-
Page 4: Chapter 1 Introduction
Chapter 1 Introduction The FWA6304-D25 series was specifically designed for the network security & management market. Network Security Applications: • Firewall • Virtual Private Network • Proxy Server • Caching Server Network Management Applications: • Load balancing • Quality of Service •... -
Page 5: System Specification
Power Supply Full range 40W Adapter / 12V Dimensions 255(W) x 156(D) x 36(H) mm 0 ~ 45 ˚C (32 ~ 113 ˚ F) Operation Temperature -20 ~ 70 ˚C (-4 ~ 158 ˚ F) Storage Temperature FWA6304-D25 Series User’s Manual... -
Page 6: Chapter 3 Hardware Configuration
Chapter 3 Hardware Configuration Motherboard (MB837-D25 Series) Layout FWA6304-D25 Series User’s Manual... - Page 7 Open Super IO GP54 GP54 Active: or setting in Low: Bypass BIOS. High: Normal 2-3 Closed ** Note that the Bypass setting in BIOS is only working when JP4 & JP5 are set as this configuration. FWA6304-D25 Series User’s Manual...
- Page 8 The SATA SSD dock combines a SATA power connector and a SATA interface connector. Signal Name Pin # Pin # Signal Name +3.3V +3.3V +3.3V +12V +12V +12V J1: SO-DIMM DDR3 Socket J2: Mini PCI-e Connector (USB signal only) J3: SPI Debug Port (Factory use only) FWA6304-D25 Series User’s Manual...
- Page 9 J9 is a DC-in internal connector supporting +12V. Pin # Signal Name +12V Ground Note: Do not connect J9 and J11 at the same time. J10: USB Header Signal Name Pin # Pin # Signal Name Ground USB1- USB2+ USB1+ USB2- Ground FWA6304-D25 Series User’s Manual...
- Page 10 PWR LED- ALARM LED+ SIO GPIO55 STATUS LED+ SIO GPIO56 SW3: Software Reset Button Signal Name Signal Name Pin # Pin # PCH GPIO7 Note: SW3 is controlled by GPIO only. SW2: Power Switch JP3: Mini-PCI Connector FWA6304-D25 Series User’s Manual...
-
Page 11: Chapter 4 Console Mode Information
Chapter 4 Console Mode Information FWA6304-D25 supports output information via Console in BIOS level. Prepare a computer as client loaded with an existing OS such Windows XP. Connect client computer and FWA6304-D25 with NULL Modem cable. Follow the steps below to configure the Windows Hyper Terminal application setting: 1. - Page 12 4. Please make the port settings to Baud rate 115200, Parity None, Data bits 8, Stop bits 1 5. Power up FWA6304-D25 and the screen will display the BIOS information. 6. Press <Tab> key to enter BIOS setup screen in Console mode.
-
Page 13: Opening The Chassis
Chapter 5 Opening the Chassis Loosen three screws on back Loosen three screws on front Remove the base The system Chapter 6 Installing CompactFlash Card Insert Compact Flash Card Push Compact Flash Card into the CF interface FWA6304-D25 Series User’s Manual... -
Page 14: Chapter 7 Installing Memory Module
Chapter 7 Installing Memory Module Fig. 7-1 Remove the film on thermal pad Fig. 7-2 Insert DDR3 SO-DIMM memory module Press down the memory module into socket FWA6304-D25 Series User’s Manual... -
Page 15: Installing 2.5" Ssd
Loosen two screws to remove left & Fasten brackets on SSD with four right side brackets screws SATA Connector Fasten both brackets on SSD with four Insert SSD into onboard SATA screws connector. Fix SSD & brackets with two screws FWA6304-D25 Series User’s Manual... -
Page 16: Chapter 9 Installing Mini Pci-E Module
Installing Mini PCI-e Module Fig. 9-1 Insert Mini PCI-e module Fig. 9-2 Push down the module into socket (Supports USB signal only) Release two clips to remove module Chapter 10 Lock Power Connector Plug power connector into power jack FWA6304-D25 Series User’s Manual...