Simple Setup - Panasonic SC-HT730 Operating Instructions Manual

Simple setup

1
STEP
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥Make sure you have all the indicated components before starting assembly, setup, and connection.
≥There is no difference between the right and left speakers and pipes.
[HT730]
2 Front 4 Pipes
≥2kpipe A
speakers
(with cable)
You can use the front speakers without assembling with the stands. In this case, attach the included
rubber pads to the base of the speakers. This prevents vibration from causing the speakers to move
or fall over. Use 3 or 4 pads per speaker.
1
Attach the pipes to the bases.
1
Insert pipe B.
Match these holes when you
insert the pipe.
2
Secure pipe B to the base.
Ensure the screws are securely fastened.
2
Assemble the pipes.
1
Thread the speaker cable from pipe A through pipe B and
the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the pipe, and then pull
the rest of the cable through the base.
Pipe B
2
Join pipe A to pipe B.
Pipe B
3
Secure the pipes.
Ensure the screws are securely fastened.
Pipe B
RQT7972
4
Front speaker assembly
2 Bases
≥2kpipe B
Pipe B
Base
Washer screws
Phillips-head screwdriver
(not included)
Cable
Cable
Pipe A
Small screws
Pipe A
The supplied stands are specially designed for
attachment to Panasonic SB-FS730 or SB-FS930
front speakers. Use only as indicated in this setup.
4 Washer 4 Bracket 4 Small
screws screws screws
3
Attach the pipes to the speakers.
Slot the screw head in between the 2 stoppers of the speaker
groove.
Ensure the pipe is fastened on straight by gradually tightening the
right and left screws alternately until fully tightened.
To prevent a short-circuit, do not cover the connection
terminals with the pipe.
Pipe A
Front speaker
4
Connect the speaker cables.
Twist off the vinyl ends of the
speaker cables.
_:
White
`:
Blue
5
Secure the speaker cables to the bases.
1
Press the speaker
cable into the base
cover groove as far
as possible.
Cable
Bottom of the base
2 Brackets Sheet of
rubber pads
Bracket screws
Bracket
Screw head
Stoppers
Connection terminals
Rear of the speaker
Push!
2
Press the
speaker cable
against the base
while threading
it between the
pegs.