Preparation Of Top Cabinet; Adapting Blower For Top Exhaust - GE JVM1500 Series Installation Instructions Manual

C2 USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through
and a cutout large enough for the exhaust adapter.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
C3 ADAPTING BLOWER FOR
TOP EXHAUST
Remove and save screws that hold blower plate
1
and blower unit to the oven.
Slide the blower plate from under its retaining
2
flange and lift it off.
Retaining Flange
Installation Instructions
Blower Plate Screws
Back of Oven
Blower Plate
Carefully pull out the blower unit. The wires will
3
extend far enough to allow you to adjust the
blower unit.
Roll the blower unit 90° so that fan blade openings
4
are facing up.
BEFORE: Fan Blade
Openings Facing
Forward
AFTER: Fan Blade
Openings Facing Up
20
Back of Oven
Back of Oven
Roll
Back of Oven
Back of Oven