When Replacing The Charcoal Filter - GE JVM1500 Series Installation Instructions Manual

A3 MOUNT THE OVEN
Cabinet Front
Cabinet Bottom Shelf
Oven Top
Attach the oven to the top cabinet by inserting
3
2 self-aligning screws through outer top cabinet
holes. Turn two full turns on each screw. Be sure
to keep power cord tight. Be careful not to pinch
the cord, especially when mounting flush to
bottom of cabinet.
4 Tighten the two screws to the top of the oven
completely. (While tightening screws, hold the
oven in place against the wall and the top
cabinet.)
5 Install grease filters. See the Owner's Manual
packed with the oven.
Installation Instructions
(cont.)
Filler Block
Equivalent
to depth of
cabinet recess
Self-Aligning Screw
A4 WHEN REPLACING THE
CHARCOAL FILTER
If the model is not vented to the outside, the air will
be recirculated through a disposable charcoal filter
that helps remove smoke and odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to
12 months, depending on hood usage). See your
Owner's Manual for the filter kit number.
To replace the charcoal filter:
Remove 2 screws on top of grille using a Phillips
1
screwdriver.
Open the door.
2
Remove the grille.
3
Slide the old filter to the front of the oven and
4
remove it.
Remove plastic and other outer wrapping from the
5
new filter and install the new filter. When properly
installed, the wire mesh of the filter should be
visible from the front.
Replace the grille and the 2 screws.
6
Close the door.
7
Insert mesh-side up
14
Charcoal Filter