Assemble And Install Adapter; Mount The Oven - GE JVM1500 Series Installation Instructions Manual

C3 ADAPTING BLOWER FOR
TOP EXHAUST
Place the blower unit back into the opening.
5
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
Replace blower plate with the screws removed in
6
Step 1.
C4 ASSEMBLE AND INSTALL
ADAPTER
Place the oven in its upright position, with the
1
top of the unit facing up.
Insert the tabs on each side of the damper into
2
the holes at the inside rear of the adapter.
Attach the exhaust adapter to the blower plate
3
with the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the oven is installed.
Installation Instructions
(cont.)
Blower Plate Screws
Back of Oven
Damper
Exhaust Adapter
Blower Plate
Back of Oven
C5

MOUNT THE OVEN

FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over tightening
screws.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by
pulling cord.
Rotate front of
2
oven up against
cabinet bottom.
21
Lift oven, tilt it
1
forward and
hook slots at back
bottom edge onto
two lower tabs of
mounting plate.