Installation Overview; Outside Back Exhaust (Horizontal Duct); Outside Back Exhaust; Attach Exhaust Adapter To Wall Plate - GE JVM1500 Series Installation Instructions Manual

B

OUTSIDE BACK EXHAUST

INSTALLATION OVERVIEW

B1. Prepare Rear Wall
B2. Attach Mounting Plate to Wall
B3. Prepare Top Cabinet
B4. Adjust Blower
B5. Mount the Oven
B1 PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
F
H
Place the mounting plate against the rear wall and
1
align it with the holes drilled earlier.
Using a pencil, put dots through holes/notches F,
2
G, H and I (see above illustration). Remove the
mounting plate and draw lines extending through
the points. This will give the location and size of
the box cutout for the rear wall duct.
3 Use a saw (saber or keyhole) to cut out the
opening.
Installation Instructions
G
I
15
(Horizontal Duct)
B2 ATTACH THE EXHAUST
ADAPTER TO THE WALL PLATE
Insert the tabs on each side of the damper into
1
the holes at the inside rear of the adapter.
Attach the exhaust adapter to the back of the wall
2
plate by sliding it into the guides at the top center
of the back of the plate.
Exhaust Adapter
Slide exhaust
adapter into
guides on
wall plate
Guide
Push in securely until it is in the lower locking
tabs. Take care to assure the damper hinge is
installed so that it is at the top and that the
damper swings freely.
Exhaust Adapter
Damper
(hinge side up)
Guide
Locking Tabs