Yamaha RX-N600 Owner's Manual page 17

Connecting the speaker cable
1
Remove approximately 10 mm of insulation
from the end of each speaker cable and then
twist the exposed wires of the cable together
to prevent short circuits.
10 mm
2
Loosen the knob.
Red: positive (+)
Black: negative (–)
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire.
Connecting the banana plug
(except Europe model)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables.
Banana plug
1
Tighten the knob.
Red: positive (+)
Black: negative (–)
2
Insert the banana plug connector into the
end of the corresponding terminal.
CONNECTIONS
15
En