Attention At The End Of Ｊｏｂ - Labokey 8101SL Instruction Manual

When the space is about 2-5mm, close Paper Holder Cover,
send papers out by manually turning [Paper Feed Knob] while
drawing paper by hand to prevent undesired sticking of paper.
During this salvage procedure, make sure that next print is
laminated correctly. If correct laminating goes on, depress
[START/STOP] switch to resume operation. If the space
between prints exceeds 5mm or more, the laminating tape
will have to be reset.
5-4 ATTENTION AT THE END OF JOB
When a job ends, leaving the machine unused for a while,
make [Paper Holder] slightly raised to prevent possible
deformation of [Paper Feed Press Roller].
How to raise [Paper Holder]:
1. Unlock [Paper Holder] by turning [Paper Holder
Lock Lever]clockwise..
2. Lift [Paper Holder] slightly by hand and replace
[Paper Holder Lock Lever]. (The spring automatically
replaces the lever.)
3. Gently lower [Paper Holder]. Hook will keep [Paper Holder] slightly raised.
Paper Holder
16
Space
Space Sensor
Paper Holder
Lock Lever