Table of Contents
Advertisement
3. Start Laminating and Kiss-Punching Work.
The operations described below are required for both L8100 and
L8101SL.
L8101SL
After setting [Laminating Tape] and [Paper] correctly, depress
[AUTO] switch. [AUTO] switch and [SEN.ON] LED are lighted on.
Then, depress [START/STOP] switch. LED of [START/STOP]
switch is lighted on. Ready to start the laminating work.
L8100
Depress [AUTO] switch. LED of [AUTO] switch is lighted on.
It is ready to start L8100 operation..
4. Indication of papers exhausted:
L8101SL
When the papers have run out, [P.END] LED lights, operation
comes to stop and the buzzer gives the warning.
Buzzer sound indicating detection of the end of papers ―― ――
Depress the [START/STOP] switch to turn off the LED and
silence the buzzer.
Note: Ensure to depress [START/STOP] switch.
When prints are stacked for laminating the P. END LED turns
off, indicating the unit is again ready for operation
L8100
When the papers have run out, the L8100 operation comes to stop
and [AUTO] switch LED goes on-and-off, and the buzzer gives
warning. Depress [AUTO] switch.
LED of [AUTO] goes off and silence the buzzer.
Note: Ensure to depress [AUTO] switch.
For restart the operation, load the paper, and feed the paper by turning
[Paper Feed Roller Knob] and lift [Accumu-Roll] up the highest position,
and then return to the step (3).
- 14 -
〇
〇
POWER
P.END
SPACE
SEN.ON
―
〇
START/STOP
〇
〇
POWER
P.END
SPACE
SEN.ON
―
〇
START/STOP
MANUAL
STICKER
〇
POWER
P.END
SPACE
SEN.ON
―
〇
START/STOP
〇
POWER
P.END
SPACE
SEN.ON
―
〇
START/STOP
MANUAL
STICKER
AUTO
AUTO
AUTO
AUTO
AUTO
AUTO
Advertisement
Table of Contents
