Setting Paper - Labokey 8101SL Instruction Manual

5. Put the sheet of paper with the tape pasted
through outside [Tape Guide Roller] and
[Laminating Roller] and draw it out straight
from underneath [Paper Feed Pressure Roller].
Place the paper on [Laminating Roller].
Adhesive side of the tape now faces upward.
6. Lower [Paper Holder] and hold it in position
with [Paper Holder Lock Lever] while lightly
pulling the paper to prevent slackening of tape.
If the [Paper Holder] does not come down all
the way and cannot be locked, turn [Paper
Feed Knob] clockwise to get the gears engaged
so that the holder will come down and get locked.

5-2 SETTING PAPER

Notes: 1. Note that papers set in the unit will be laminated one by one from lower end.
2. When papers are stack with uneven ends, front and rear in particular, it might
cause improper laminating.
3. When papers are stack with uneven sides laminating may not be straight.
4. Do not set more than 100 sheets of paper at a time.
5. When papers are curly limit the number to 70 sheets.
Explanation now refers to when the tape is correctly set.
Width of paper may be adjusted by turning [Paper Width Adjust Knob] on the back of [Paper
Holder]. It may be done manually with the [Paper Holder] set in position.
Set papers by opening [Paper Holder Cover] after having locked [Paper Holder].
With Paper Holder opened
Paper Width
Adjust Knob
Hook
Paper Width
Fixing Knob
Paper Holder Lock Lever
Tape Guide Roller
Paper Holder Lock Lever
With Paper Holder Cover opened
Paper Length Block
10
Paper
Holder
Paper Feed
Pressure
Roller
Laminating Roller
Gear
Paper Feed Knob
Separator