Installing The Camera - Panasonic SD WV-NW484S Operating Instructions Manual

Installing the Camera

1
Install the mounting bracket.
Fix the mounting bracket directly into
the ceiling or wall or into the
imbedded box using the four screws
prepared in advance. (Note that
screws for installation are not
provided.)
When using the imbedded box, we
recommend using two boxes in a row
as shown in the figure below on the
right. (This is to make it easier to pass
the cables through.)
..................................................
Note
• When installing the camera
outdoors, waterproof the screws
and screw holes.
......................................................
2
Loosen the three screws and remove
the enclosure.
Unscrew the screws using the driver
bit (provided).
..................................................
Note
• When replacing the dome cover
(WV-CW4C, sold separately),
refer to the Operating Instructions
provided with the dome cover.
......................................................
Cable pass-through
hole
85 mm
Installation screws x 4
83.5 mm
Installation screws x 4
85 mm
Cable pass-through
hole
51 mm
Center of metal installation bracket
46 mm
21