General; Lubrication Chart; Lubrication 7.1 General - Jacobsen super lf 1880 Dealer's Manual

7 LUBRICATION
7.1

GENERAL _______________________________________________________________________________

7 LUBRICATION
!
Before you clean, adjust, or repair this equipment, disengage all
drives, lower implements to the ground, engage parking brake,
stop engine, and remove key from ignition switch to prevent
injuries.
1. Always clean the grease fitting before and after lubricating.
7.2

LUBRICATION CHART _____________________________________________________________________

H
F
F
F
H
E
F
L
J
K
I
K
J
N
22
WARNING
G
G
H
F
L
2. Lubricate with grease that meets or exceeds NLGI Grade 2 LB
specifications. Apply grease with a manual grease gun and fill
slowly until grease begins to seep out. Do not use compressed
air guns.
3. Periodically apply a small amount of lithium based grease to the
seat runners.
4. For smooth operation of all levers, pivot points, and other friction
points that are not shown on the lubrication chart apply several
drops of SAE 30 oil every 40 hours or as required.
5. Grease fittings (A - I) every 50 hours, fittings (J - M) every 100
hours and (N) every 250 hours.
F
F
M
F
A - Steering Axle Pivot
B - Spindle Pivot (2)
C - Steering Cylinder (2)
D - Tie Rod (2)
E - Brake Pivot
F - Lift Cylinder (10)
G - Lift Arm Pivot (10)
H
D
G
D
H
B
H - Lift Arm (10)
I - Lift Yoke (5)
J - Bearing Housing (10)
K - Front Roller (10)
L - Rear Roller (10)
M - Drive Shaft (3)
N - Motor Spline
B
C
A
C