4Set-Up; General; Initial Inspection; Reels - Jacobsen super lf 1880 Dealer's Manual

4 SET-UP
4.1 4 Set-up

GENERAL _______________________________________________________________________________

The set-up and testing of the unit should always be performed by a
trained technician, familiar with the operation of this equipment.
Read each instruction completely and make sure you understand it
before proceeding with the assembly. Stay alert for potential hazards
and obey all safety precautions.
The RIGHT and LEFT, FRONT and REAR of the machine are
referenced from the operator's seat, facing forward.
4.2

INITIAL INSPECTION ______________________________________________________________________

!
The initial inspection should be performed only when the engine is
off and all fluids are cold. Lower implements to the ground,
engage parking brake, stop engine and remove ignition key.
1. Perform a visual inspection of the entire unit, look for signs of
wear, loose hardware, and components that may have been
damaged during transport.
2. Inspect paint and decals for damage or scratches. Decals
provide important operaing and safety information. Replace all
missing or hard to read decals.
3. All fluids must be at the full level mark with engine cold.
4.3

REELS __________________________________________________________________________________

1. If installing five inch reels, apply Moly EP grease to female spline
on reel, and insert reel coupler (A) into the bearing housing
before attaching reel motor.
2. Install any special rollers or reel attachments following
instructions included with them.
10
CAUTION
A
Accessories not included with this product must be ordered
separately. See instructions provided with accessory for installation
and parts.
Do not attempt to drive the tractor unless you are familiar with this
type of equipment and know how to operate all controls correctly.
Check :
a. Radiator coolant level.
b. Engine oil level.
c. Hydraulic fluid level.
4. Make sure air filter connections are tight and cover is securely
in place.
5. Check tires for proper inflation. Tires have been over inflated for
transport. Correct tire pressure should be set to 10 psi.
6. Check belt tension.
[Section 5.2]
7. Inspect battery connections and electrolyte level. Check that
battery is fully charged.
8. Check for fuel or oil leaks.
1. Inspect lube points on reels and tractor for proper lubrication.
[Section 7.2]
3. Set bedknife-to-reel adjustment.
[Section 5.11, 5.12]
4. Adjust cutting height to customer specifications.
[Section 5.13]
5. Install reels on tractor. Refer to flash attach procedure.
[Section 5.15]
6. Assemble the down pressure springs to each reel.
a. Insert roll pin (A) into hole at the end of down pressure tube
(B).
b. Slide tube through hole in lift yoke.
c. Assemble spring (C), washer (D), 3/8-24 hex jam nut (E) and
Figure 4A
rod end (F) to tube (B) as shown.
d. Secure down pressure assembly to the reel frame using one
3/8-16 x 1-3/4" screw (G), spacer (H), lockwasher (J) and 3/8-
CAUTION
!