Zanussi ZWC 1301 User Manual page 20

you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The drain hose can be hooked over the edge
of a sink using the plastic hose guide supplied
with the machine. Make sure that the sink is
empty and the plug hole is not blocked.
If the machine is permanently plumbed in,
hook the end of the hose into a standpipe in-
stalled for the purpose. The standpipe must
have an internal diameter of at least 40 mm (1
1/2") in order that there is an air gap between
the drain hose and the standpipe. Make sure,
that it is designed in such a way, that the end
of the drain hose cannot be covered with wa-
ter.
Whether discharging into a sink or a stand-
pipe, check that the end of the drain hose is
neither too high or too low. The top of the
curve in the hose's end should be no more
than 800 mm (31.5"), and no less than 650
mm (25.6") above floor level.
20
Make sure the end
cannot come un-
hooked when the
machine is emptying.
This could be done
by tying it to the tap
with a piece of string
or attaching it to the
wall.
40 mm
650-800 mm
40mm (1 1/2") diameter
standpipe
The drain hose can be extended up to total 3,5
m. For the extension piece use a hose with an
internal diameter at least as large as that of the
machine's own hose. Use a suitable hose con-
nector.
Electrical connection
Any electrical work required to install this ap-
pliance should be carried out by a qualified
electrician or competent person.
Warning! THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should this safety measure not be
observed.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the appliance's rating plate.
Warning! Information on the
electrical connection is given on the
rating plate on the inner edge of the
appliance door.
The appliance is supplied with a 13 amp plug
fitted.
In the event of having to change the fuse in the
plug supplied, a 13 amp ASTA approved
(BS1363/A) fuse must be used.
Should the plug need to be replaced for any
reason, proceed as described below.
www.zanussi.com