Zanussi ZWC 1301 User Manual page 19

Return machine to it's upright position and
remove the power supply cable and the
draining and inlet hose from the hose hold-
ers on the rear of the appliance.
With a suitable spanner unscrew and re-
move the three screws and their spacers on
machine's rear.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or furni-
ture. Level the washing machine by raising or
lowering the two front feet. If necessary, check
the setting with a spirit level. Any necessary
adjustment can be made with a spanner. Ac-
curate levelling prevents vibration, noise and
displacement of the machine during operation.
www.zanussi.com
The three holes must
then be plugged with
the plastic plug caps
supplied in the bag
containing the in-
struction booklet,
which can be found
inside the drum.
Caution! Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the floor.
Water inlet
Warning! This appliance must be
connected to a cold water supply
Caution! Before connecting up the
appliance to new pipework or to pipework
that has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected
Caution! Do not use the hose from your
previous appliance to connect to water
supply.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
Connect the hose to
a tap with a 3/4"
thread. Always use
the hose supplied
with the appliance.
The machine end of
the inlet hose can be
turned in any direc-
tion. Set the hose
correctly by loosen-
ing the ring nut. After
positioning the inlet
hose, be sure to
tighten the ring nut
again to prevent
leaks.
19