Zanussi ZWC 1301 User Manual page 14

• Select the hottest cotton wash programme.
• Use a normal measure of detergent, must
be a powder with biological properties.
External cleaning
Clean the exterior cabinet of the appliance
with soap and water only, and then dry thor-
oughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser
drawer should be cleaned regularly.
When you put it back, press it downwards un-
til you hear a distinct click.
Cleaning the drawer recess
14
If necessary, the
whole detergent
drawer can be taken
out of the machine
for cleaning. You
need to pull it firmly
outwards, so that it
comes free of retain-
ing stop.
To remove the si-
phon at the inside
edge of the drawer
for cleaning, you
need to press it in-
wards and pull it up-
wards at the same
time. Flush it out un-
der a tap, to remove
any traces of accu-
mulated powder.
Having removed the
drawer, use a small
brush to clean the re-
cess, ensuring that
all washing powder
residue is removed
from the upper and
lower part of the re-
cess.
Replace the drawer and run the rinse pro-
gramme without any clothes in the drum.
Cleaning the water inlet filter
If your water is very hard or contains traces of
lime deposit, the water inlet filter may become
clogged. It is therefore a good idea to clean it
from time to time.
The dangers of freezing
If the machine is exposed to temperatures be-
low 0°C, certain precautions should be taken.
• Turn off the water supply.
• Unscrew the inlet hose from the supply tap.
• Select a wash programme, start the ma-
chine and let the programme run for a short
time.
• Interrupt the programme by turning the pro-
gramme selector to
• Place the end of inlet and drain hoses down
low, into the waste gully (floor drain) set into
the floor. Make sure that the end of the hose
does not go below the water level in the
gully's (drain's) water tap.
• Select the programme "Drain" and let it run
until it is finished.
• Turn the programme selector to
When you intend to start the machine up
again, make sure that the room temperature
is above 0 °C.
The appliance is only to be used and stored
indoors at normal room temperature. The man-
ufacturer is not responsible for any frost dam-
age.
Turn off the water
tap. Unscrew the wa-
ter inlet hose. Clean
the filter using a hard
bristle brush. Tighten
up the inlet hose.
position.
position.
www.zanussi.com