Mounting the Tuner Unit
Never mount the unit in any of the following locations to avoid damage due to overheating;
• Near the heater port.
• Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
Do not mount the unit near the door, where it could be exposed to rain.
You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring harness, or
For mounting the unit on inclined surface, Velcro tape ﬁ xation is too weak, and screw
ﬁ xation is recommended.
Apply an anticorrosive to the holes and tapping screws.
Keep a safe distance between the unit and other electronic equipment.
Unit Installation by using the Tapping
Screw . (Recommended)
Mount the unit on the car carpet
by using Velcro tape .
Attach the seal side of the Velcro Tape to the unit, then
mount the unit on the carpet.
Some carpet materials may not be suitable for this
mounting method. In this case, please contact your
nearest Panasonic Servicenter for installation.
Connecting the Parking Brake (Side Brake) Connection Lead
For safety, be sure to ask your nearest professional
installer to do this connection.
The parking brake (side brake) switch position varies with the car
model. For details on the exact location of the parking brake (side brake)
switch in your car, contact your dealer.
Parking Brake (Side Brake) Connection
When the parking brake (side brake) lever
is engaged, the unit is grounded by the
Attach a Clip Connector to the end of the parking
brake (side brake) connection lead.
Come up to this point.
Parking Brake (Side Brake)
Parking brake (side brake)
The Clip Connector is connected to the power
source side lead of the parking brake (side brake)
Power source side lead