Operation Check Procedure - Panasonic UB-5338C Operating Instructions Manual

Electronic Board Operations Check

■ Operation Check Procedure

After assembling the unit and setting the time, perform the procedures presented in the following table to make sure
it functions properly.
Step
1 Turn the power switch on.
2 Press the Advance Key.
3 Connect a USB flash memory
device or SD memory card.
4
Use the accessory marker
to draw a large
across the entire
scannable area of the
screen film surface.
• For information on the
scannable area, refer to
"Screen Film" on page 12.
Press the Start/Stop Key.
5 Zoom in on several areas of the
scanned image.
(See page 18 and 19.)
6 Turn off the power switch, then
turn back on after 3 minutes.
46
Condition
The standby message is displayed
after the initial message is
displayed.
Display does not appear.
An error code appears on the
display.
Screen is fed.
The screen film surface is not fed
smoothly.
There are strange noises.
The USB flash memory device or
SD memory card installed is shown
on the display.
(If not)
The screen film moves smoothly
and the scanned image appears on
the display.
(If not)
A black or white horizontal line
appears on the scanned image, or
the image scanned is dark or blank.
The entire scannable area is not
scanned.
The standby message is displayed
after the initial message is
displayed.
The time is not correct.
Points to Check
Solutions
(Normal operation)
Check the power cord.
(See step 2 on page 45.)
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Contact the store or dealer from
which the unit was purchased.
Check the strong lighting.
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Check the battery.
(See step 3 on page 45.)